Tehnički kutak > Garaža
Piaggio Beverly 250 i.e by Dacerovs
balki:
Si provjerio lambda sondu, očistio filter zraka i očistio kanale u tijelu usisa sa carb cleanerom?
stipe:
--- Citat: dacerovs - 02 Srpanj, 2019, 06:36:28 ---Jesi gledao svjecicu? Ako jesi kakve je boje?
Jesi klemu skinuo sa akua na 2-3 min da se resetira?
--- Kraj citata ---
nisam, mogu popodne...
nisam ni to drugo. i to cu kad dodjem dom.
--- Citat: balki - 02 Srpanj, 2019, 10:21:43 ---Si provjerio lambda sondu, očistio filter zraka i očistio kanale u tijelu usisa sa carb cleanerom?
--- Kraj citata ---
kako se provjerava?
filter zraka i usis sam cistio
balki:
voltmetrom. Imaš proceduru i vrijednosti u servisnom manualu od strane "injection- 47". Ovo si izgooglaj i skini: piaggio-beverly-cruiser-250-ie-workshop-manual
Kolko vidim ima 3 ili 4 žice. (Masa/e, Sonda, Grijač) pa mjeriš između Mase i Sonde. Otpor grijača piše da mora bit cca 9 Ohm pri sobnoj temp i spojen je grijač preko osigurača.
With the engine cold, check the resistance of the
Lambda sensor heater between pin 21 of the interface
wiring and the black green cable of the
injection load remote control base, with the control
unit disconnected and the remote control disconnected.
Resistance of the heater at approximately 20° = 9
Ohm ± 20%
Install the electronic control unit interface wiring.
Start the engine and warm up until the electric fan
switches on.
Use an analogue multimeter with a direct voltage
scale measuring down to 2 V.
Place the tips of the multimeter between pins 4 (-)
and 11 (+)
With the engine running at idle speed, check that
the voltage oscillates between 0V and 1V
With the throttle valve completely open, the voltage
is approx. 1V.
During the closing phase, the voltage is approx.
0V.
If the voltage remains constant, the sensor may be
damaged. Remove the sensor and check that
there are no oil or carbon deposits inside it..
dacerovs:
--- Citat: balki - 02 Srpanj, 2019, 10:21:43 ---Si provjerio lambda sondu, očistio filter zraka i očistio kanale u tijelu usisa sa carb cleanerom?
--- Kraj citata ---
Balki, slobodno se raspisi o svemu :D
Ovo moram i ja napravit. Nekad mi zna kad je full hladan i kad malo taknem gas te ga pustim da se smiri na ler, ugasit. Vjerojatno treba TPS ocistit i sve ostalo kako si naveo, vec sam citao o tome. Carb cleaner mi je u steku vec dugo i vec sam se pitao za sta da ga koristim kad vise karb nemam hahaha.
Sent from my iPhone using Tapatalk
balki:
Ja za sve to koristim brake cleaner (isti q drugo pakovanje).
Kad se sve to dovede u red onda ga malo vozit pa nakon par dana odvest u Moto Mondo, ocitat greske, stavit zadnji softver i resetnut TPS i samo gas nakon toga..
Navigacija
[0] Lista Poruka
Idi na punu verziju