Samo da javim da sam uspio upariti simulator s autom. Mislim da je bio problem što prvi puta nisam kretao iz mjesta. Usput sam naišao na metodu pomoću koje Suzuki ulazi u learning mode za TPMS ventile, u nastavku je c/p procedura s interneta, možda nekom pomogne
Not using SUZUKI Scan Tool
1) Confirm that all doors are closed and the ignition mode of the keyless push start system is “OFF”.
2) Open the driver's side door.
3) Perform the following Steps a) to c) within 15 seconds after changing ignition mode to “ON”.
a) Press driver side door switch within 5 seconds after changing ignition mode to “ON”. Keep pressing the driver-side door switch for 2 seconds.
b) Release the driver-side door switch and then press the driver-side door switch for 2 seconds or more.
c) Release the driver-side door switch and then press the driver-side door switch for 2 – 5 seconds.
4) Using recommended tool (“VT55” made by ATEQ) (1), activate each tire pressure sensor within 180 seconds.
Refer to the instructions of recommended tool for the method of activating the tire pressure sensor.
5) Push the engine switch to change the ignition mode to “OFF” after registration is completed.
NOTE:
• When the tire pressure sensor is activated, the ID code of the tire pressure sensor is registered automatically in the keyless start control module.
• If all 4 tire pressure sensor ID codes are not registered in the keyless start control module within 180 seconds, perform the above steps again. Also, it is possible to check the number of tire pressure sensor ID codes received by the keyless start control module by observing the flashing pattern of the low tire pressure warning light.
• If the registration of tire pressure sensor ID codes is not completed within 180 seconds, former ID codes remain in the keyless start control module.
• When the keyless start control module receives all 4 tire pressure sensor ID codes, the keyless start control module turns ON the low tire pressure warning light in combination meter for 5 seconds.
