Tehnički kutak > Skuter projekti - komentari

Runner 180 midrace stroker - by mala tvornica zla

<< < (5/6) > >>

gumy:
Ja sam imao problem ali su rikavali polumjesec i zubčanik što okrene radilicu, i to redovno, problem je bio u spuštenoj glavi i komp. omjeru preko 15:1 (naravno da je i klipnjača prolupala  :drunken_smilie:)

memphis:
Dobro gumy squish mi je 1mm kb glava, ajde bas cu sutra izmjerit kompresiju

steeef:
tomi na kakvom ventilvaru ima 4t upresan zupcanik uljne?




--- Citat: memphis - 27 Prosinac, 2016, 22:31:22 ---Dobro gumy squish mi je 1mm kb glava, ajde bas cu sutra izmjerit kompresiju

--- Kraj citata ---

kompresioni omjer se treba izracunat,mjerenjem kompresije nebudes saznal omjer..

Tomi_ZG:

--- Citat: steeef - 28 Prosinac, 2016, 10:25:13 ---tomi na kakvom ventilvaru ima 4t upresan zupcanik uljne?

--- Kraj citata ---
Mislio sam na ovaj tjunerski

http://www.scooter-center.com/en/product/KBR001/Front+half+pulley+KB+Racing+Piaggio+125+200+ccm+Leader


--- Citat: ---Made in Germany! Toothing of the oil pump sprocket is eroded into the half-pulley. After that, the sprocket is pressed into the pulley by means of interference measurement and then machined on the lathe.
Thanks to the massively reinforced cogging of the pulley, the starter engine’s force will no longer damage the crankshaft’s toothing.
Especially recommendable for tuned engines.
--- Kraj citata ---

SF2 Freak:
Ovo kaj je tomi stavio moglo bi biti uper kombinacija.

Navigacija

[0] Lista Poruka

[#] Slijedeća stranica

[*] Prethodna stranica